全部分类
首页设计与方案LMP8646EB/NOPB_TI(德州仪器)中文资料_英文资料_价格_PDF手册
LMP8646EB/NOPB_TI(德州仪器)中文资料_英文资料_价格_PDF手册
阅读量:2

LMP8646EB/NOPB

LMP8646 评估板


image.png

The LMP8646 Evaluation Board (LMP8646EB) is designed to ease evaluation and design-in of Texas Instruments’ LMP8646, a Precision Current Limiter.  The LMP8646 is used to detect small differential voltages across a sense resistor in the presence of high input common mode voltages.  On board with the current limiter is the LM3102, a Step Down Switching Regulator that is capable of supplying 2.5A to loads.  This document describes super cap and resistive load applications utilizing the LM3102 voltage regulator and the LMP8646 precision current limiter.  The document also provides the schematic, layout, and BOM for the LMP8646 evaluation board.  


LMP8646EB 的特性

  • Provides circuit protection and current limiting

  • Single supply operation

  • -2V to +76V common mode voltage range

  • Variable gain set by external resistor

  • Adjustable bandwidth set by external capacitor

  • Buffered output

  • 3% output accuracy achievable at VSENSE - 100 mV

LMP8646EB 的说明

The LMP8646 Evaluation Board (LMP8646EB) is designed to ease evaluation and design-in of TI's LMP8646, a Precision Current Limiter. The LMP8646 is used to detect small differential voltages across a sense resistor in the presence of high input common mode voltages. On board with the current limiter is the LM3102, a Step Down Switching Regulator that is capable of supplying 2.5A to loads. This document describes super cap and resistive load applications utilizing the LM3102 voltage regulator and the LMP8646 precision current limiter. The document also provides the schematic, layout, and BOM for the LMP8646 evaluation board.

Quick Start: Supercap Application


A supercap application requires a very high capacitive load to be charged. This example assumes the output capacitor is 3.3F with a limited load current at 1.5A. The LM3102 will provide the current to charge the supercap, and the LMP8646 will monitor this current to make sure it does not exceed the desired 1.5A value.  


This is done by connecting the LMP8646 output to the feedback pin of the LM3102, as shown in Figure 1. This feedback voltage at the FB pin is compared to a 0.8V internal reference.  Any voltage above this 0.8V means the output current is above the desired value of 1.5A, and the LM3102 will reduce its output current to maintain the desired 0.8V at the FB pin.  


The following steps show the design procedures for this supercap application.  The  first  step  is  to   select  the  discrete components  for  the  LM3102  by  following  the design  steps described in its application note. Next, integrate the LMP8646 into  the  system  and  select  the  proper  values  for   its  gain, bandwidth, and output resistor. Lastly, capture the results and adjust the components to yield the desired performance.  

image.png




LMP8646EB/NOPB LMP8646 评估板